It was the -enable-lxi-gui flag that I was missing. Has anyone tried this on their DS1054Z scope and did it work? Not shown: 996 closed ports PORT STATE SERVICE 80/tcp open http 111/tcp open rpcbind 617/tcp open sco-dtmgr 5555/tcp open freeciv Nmap done: 1 IP address (1 host up) scanned in 0.13 seconds I did a Wireshark capture of sending an *IDN? in UltraSigma and the rather weird thing is that it seems to be using port 618, which nmap does not even list as open? I am using the lates available firmware 00.04.04.04.03, which is shown as 00.04.04.SP4 on the scope in System Information. Aside from the fact that the connection stays open in nc, I have confirmed that port 5555 is open: Starting Nmap 7.60 ( ) at 23:05 BST Nmap scan report for 10.210.210.162 Host is up (0.0047s latency). The scope does respond when using the SCPI command console in UltraScope.
#PORT 5555 FREECIV WINDOWS#
I tried the same on Windows but with the same result. I can connect to port 5555 using nc, telnet or PuTTy in RAW mode and the connection holds, but the scope just does not respond to anything including *IDN?. I read recently in these two articles that it is possible to get a screenshot from a Rigol DS1054Z via the command line on Linux: Since I use Linux most of the time, I had hoped this would be useful, however the problem is that it doesn't seem to work.
0 kommentar(er)
